Does the coupling of 10 to 12 mm correspond to the engine shaft of 6 mm?

Question

Accepted Answer

Does the coupling of 10 to 12 mm correspond to the engine shaft of 6 mm?Not for direct attachment. The results shall correspond to the actual diameters of the two shafts. For a nominal 6 mm motor shaft and 8 mm drive axle select the coupling 6 → 8 mm. Version 10 → 12 mm is for shafts with such diameters. Also check the length of clamping, alignment, torque and method of attachment. D30L35 denotes a nominal outer diameter of 30 mm and a length of 35 mm, not universal compatibility or permissible torque. Before making the carrier we check the actual dimensions; 3D models also contain details estimated by photos.Related interpretationSt Andrew's ghost: engine, regulator and birch couplingAndrew's Ghost 1: Engine construction and side shaftAndrew's Ghost 2: Controller and CouplingPresentation of DC engines with reducer snailDC engine with reduction device 5-100 RPM 3V-24V

Does the coupling of 10 to 12 mm correspond to the engine shaft of 6 mm?

Does the coupling of 10 to 12 mm correspond to the engine shaft of 6 mm?

Related interpretation

Share this content

Published:

Related products

Additional documentation